I've reached the limit of my current Map sensor (2002 WRX) and need to find a decent 3 or 4 bar sensor. Is there a PnP solution - obviously I know the map will need adjusting once fitted but Ideally I want one to fit in the OE location.

 

Not sure about direct replacement but I got mine from JTinnovations

 

the subaru 3bar sensor or the omni 3bar/4bar all go straight in.

what setup are you running to need the higher map range though - I'm guessing forged build/6speed/giant brakes/injectors etc?

 

3 bar map sensor will be fine unless you are looking to run over 2 bar of boost pressure,as above the subaru 3bar or omni one would be fine.SJ.

 

I'm running a forged 2.5 on syvecs at 1.6 bar I need to switch to the 3Bar to give a bit more headroom on the sensor and up the boost a little through the mid range.

Anybody know a UK stockist of the Omni sensors - I can't find a Subaru 3 bar sensor online?

 

I went for a Perrin and works well

 

JDM Spec C will fit direct and allow over 1.5 bar

2nd hand from breaker £30

 

I got mine direct from Omni in USA. Funky Power also do them

 

the subaru one your lookin' off a JDM car or a hatch STI

 

Will they fit the loom and the Throttle body - I'm trying to tidy up the bay at the moment and adaptors hoses etc. are to be avoided!

 

JDM Spec C is Direct fit

 

I'll give the usual breaker suspects a bell. Cheers.

 

Thats where i got mine from