Notices
Engine Management and ECU Remapping This section is to discuss the various aspects of engine management modification for your Subaru.

Electrical gremlins

Old Nov 26, 2014 | 03:43 PM
  #1  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default Electrical gremlins

Hi I'm not a subaru owner yet but have been offered a 1999 wrx at a very good price the thing is it's got so many electrical faults it's almost stupid, I know my electrics pretty well but before I invest my time in to it I need to know if anyone has had a similar problem.

The car has defi gauges and evertime I flick on the headlights the defi gauges and interior light go out, the revs also drop and prop ably the mph needle but not sure as I haven't driven it yet, starts up and revs fine tho.

I immediately thought grounding or relay issues so had a look at the ecu, it has an aftermarket apexi power fc fitted and the wiring harness has been heavily spliced into, it has a blanked connector spliced into the ecu with a crap load of wires connected to multiple wires on the ecu harness, one of the wires spliced is connected to the ecu location nut and after a few minutes it started getting very hot, I removed it and it sparks on contact leaving me to think it most definetly is a grounding issue.

Does anyone know why the previous owner has connected a blanked plug to the ecu harness?

The guy that owns it now bought the car like this so bit of a pain to figure out it's history.

Any input would be really appreciated
Reply
Old Nov 26, 2014 | 04:11 PM
  #2  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default




That's the wire that's shorting out, was connected to the nut
Reply
Old Nov 26, 2014 | 04:14 PM
  #3  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default





That's the blanked connector and the grey wires that are spliced into the ecu
Reply
Old Nov 26, 2014 | 04:18 PM
  #4  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default

Reply
Old Nov 27, 2014 | 12:08 PM
  #5  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default

Anyone???
Reply
Old Nov 27, 2014 | 12:12 PM
  #6  
piehole1983's Avatar
piehole1983
Scooby Regular
iTrader: (7)
 
Joined: Mar 2013
Posts: 2,999
Likes: 0
From: Belfast
Default

Jeez, that's a right mess! My car has a blank plug too, it's actually a junction for the incoming wires to join to eachother. I thought it was strange too but then I seen it in the wiring diagrams. Have you checked out the Ken Gilbert website for diagrams? Could be very useful for you.
Reply
Old Nov 28, 2014 | 10:22 PM
  #7  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default

Thanks for the reply mate, I've had a look but can't seem to find the ecu diagram, do you know where I can get an ecu diagram for a type ra
Reply
Old Nov 28, 2014 | 10:32 PM
  #8  
piehole1983's Avatar
piehole1983
Scooby Regular
iTrader: (7)
 
Joined: Mar 2013
Posts: 2,999
Likes: 0
From: Belfast
Default

There'll be a pinout somewhere on here, have a good dig. I'm looking now too.
Reply
Old Nov 28, 2014 | 10:36 PM
  #9  
piehole1983's Avatar
piehole1983
Scooby Regular
iTrader: (7)
 
Joined: Mar 2013
Posts: 2,999
Likes: 0
From: Belfast
Default

There's ECU diagrams shown in here, fair enough not an actual ECU pinout but you could find the stuff you're after easily enough:

http://ken-gilbert.com/wrx/mans/99-0...%20Diagram.pdf
Reply
Old Nov 30, 2014 | 04:36 PM
  #10  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default

Thank you I've had a look but I can't find it for my car, can't figure out which one refers to my ecu, some of the pins are different
Reply
Old Nov 30, 2014 | 04:36 PM
  #11  
Duncan12's Avatar
Duncan12
Thread Starter
Scooby Newbie
 
Joined: Nov 2014
Posts: 10
Likes: 0
From: England
Default

I've had a bit of time to have a look at the wiring behind the cluster and centre console, I'm getting clicking sounds from 2 different locations, I've traced one to what looks like an alarm module, why would that be clicking?? It's a metal box just above the airbag bag module, the 2nd clicking sound needs a bit more investigation but I'm pretty sure it's behind the dash, possibly the flasher relay. Will have a look tomorrow after work
Reply
Old Nov 30, 2014 | 09:54 PM
  #12  
piehole1983's Avatar
piehole1983
Scooby Regular
iTrader: (7)
 
Joined: Mar 2013
Posts: 2,999
Likes: 0
From: Belfast
Default

Check this out:

http://www.jollygreenmonster.com/pinouts.htm

As for the clicking, I couldnt say. My flasher relay is behind where the radio goes, mine is a pre-facelift though.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
Nov 4, 2021 07:12 PM
just me
Non Scooby Related
26
Jan 3, 2020 11:12 AM
Abx
Subaru
22
Jan 9, 2016 05:42 PM
dpb
Non Scooby Related
14
Oct 3, 2015 10:37 AM
the shreksta
Other Marques
26
Oct 1, 2015 02:30 PM


Thread Tools
Search this Thread

All times are GMT +1. The time now is 11:51 PM.