Dave uk blue mica

Hi I've got a 1999 T reg classic impreza turbo and I want to fit a dccd set up on it, I've got the dccd gearbox, rear diff, dccd module and wiring and the adjuster wheel all off a version 3/4 dccd car, since my car is a 1999 it's a version 5 so the clocks I need are the version 5 dccd ones, on the version 1/4 the dccd lights just plug into the back of the clocks but on the version 5 there isn't anywhere to plug the dccd light board into, anyone know if I can get the version 5 clocks to work with the version 3/4 dccd stuff I have?

**jay**

iTrader: (1)

Could just rig up sort of lights for it, the dccd will still work fine without them on the dash

Dave uk blue mica

Yes I know that and I've got the light board off the version 3/4 car but I fancied using the version 5 clocks so it would all look oem then

P1303

iTrader: (2)

I have just fitted dccd to my p1 but I think you knead v5 ecu and v5 loom and clocks and you will knead to remove you abs and all the hubs and rear drive shafts

Dave uk blue mica

Not very easy to find a version 5 loom though to get the dccd part of the loom out of the main loom so might be easier just to use the version 3/4 dccd loom, dccd ecu and the thumb wheel and mount the light bar for the dccd somewhere