Question re boost guages
26 March 2002, 07:33 PM
#1
Scooby Regular
Thread Starter
Join Date: Apr 2001
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
I was thinking of fitting a boost guage to my MY01 and had a couple of Q's:
1, how much should I pay?
2, is it a reasonable DIY job?
3, where should I buy one from?
Thanks,
Darren.
I was thinking of fitting a boost guage to my MY01 and had a couple of Q's:
1, how much should I pay?
2, is it a reasonable DIY job?
3, where should I buy one from?
Thanks,
Darren.
26 March 2002, 09:06 PM
#2
Scooby Regular
Join Date: May 1999
Posts: 779
Likes: 0
Received 0 Likes
on
0 Posts
STI gauge will cost a lot.
I went for the economy version:
Boost Gauge £24 (£12 fitting kit)- Think Automotive, 292 Worton Road, Isleworth, Middlesex, TW7 6EL - 0208 568 1172
(I just bought the gauge).
Then I got a cheap (£5) housing and some blue silicon tube (£6) from Merlin Motorsport, Castle Combe Circuit, Chippenham, Wiltshire SN14 7EX Telephone 01249 782101
Mine's mounted on the A-pillar.
Feeding the pipe through the bulkhead (grommet) was tough but I got there in the end. A couple of small screw clips secured the pipe to the gauge and the spare nipple on the inlet manifold.
I went for the economy version:
Boost Gauge £24 (£12 fitting kit)- Think Automotive, 292 Worton Road, Isleworth, Middlesex, TW7 6EL - 0208 568 1172
(I just bought the gauge).
Then I got a cheap (£5) housing and some blue silicon tube (£6) from Merlin Motorsport, Castle Combe Circuit, Chippenham, Wiltshire SN14 7EX Telephone 01249 782101
Mine's mounted on the A-pillar.
Feeding the pipe through the bulkhead (grommet) was tough but I got there in the end. A couple of small screw clips secured the pipe to the gauge and the spare nipple on the inlet manifold.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM