Hey all,

Anyone wired up the DCCD Pro by yourself? Looks simple enough for ECU box except for the brown wire (Ebrake), what the heck is that?
Red = positive
Green = neg
Black = Pin 1
White = Pin 4
Blue = TPS (Throttle yeh)

I'm also looking to change the switches to nice oe jobs from spec d but this is where the wiring becomes unknown...

The roller switch has 4 terminals and so does oe:
DCCD pro 1, Green, 2, Black 3, Red (if going by picture on website)
OE Green/white, Green, white/blue but no idea which is 1, 2, 3.

Also, manual switch worse...
DCCD pro Red, white, green and black.
OE 2 black, yellow and purple.

Anyone have an electrical guide for the oe switches?


Also, where's best location for G sensor with easy fitting?

 

Note the guide says "A suggested location for installation of the dual axis g-sensor is on the horizontal metal
surface under the center console.". By center console do they mean the gear stick/handbrake area?

 

Just had non delivery to sales@dccdpro.com which is the only contact on that website...

Anyone have any other contact details or how to do warranty claims?

 

The sales email address is correct, Jeff is at the other end. All good there, just wonder if anyone has fitted the brown wire to the handbrake themselves? I cant see where the connector is (unless its the item at the front of the handbrake?) as I'd like to do the diodes and have both wired in as per the install guide.