dp to mid-section connection question
#1
I was just refitting the dp to mid at the weekend (one of the bolts had fallen out!!!! not fitted by me, I add ) & was wondering about how tight the connection should be. Obviously tighter than it was before , but 'cos of the design of that bit, I presume it's meant to take some movement. And the amount of movement depends on how tightly the thing is done up.
Anyone got any hints?
Anyone got any hints?
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM