Gearbox removal
#1
Gearbox removal
hi all, trying to remove the gearbox on a 98 sport, non turbo taken all the bell housing bolts off and its still stuck solid to the engine, it also doesnt have the allen headed bung to remove the clutch arm, HELP! i must be missing something!
#2
Scooby Regular
iTrader: (1)
Join Date: Feb 2006
Location: S.W. Scotland
Posts: 723
Likes: 0
Received 0 Likes
on
0 Posts
Took me a while to seperate mine. Ended up having to get a thin chisel and thick paint scrapper to part it. They are a pain in the **** to remove and fit. Fitting them is even worse.
#3
Scooby Regular
Join Date: Sep 2000
Location: Deepest Darkest Dorset!!
Posts: 10,011
Likes: 0
Received 1 Like
on
1 Post
Mine took 2 days, and lots of swearing to get off..... i had to remove it again a few weeks later, and thinking it'd be stuck again, i pulled it, and it fell on my chest..... that hurt!!
#4
Scooby Regular
iTrader: (59)
Have you removed the large pin that goes through the clutch release bearing fork. If not you wont get the gearbox out until you remove it. Just below where the starter sits there is a big round blanking plug with an alan key drive, remove this and thread a bolt, think its M8 into the pin which will be in the hole left by removal of the blanking plug and pull it out. It may be very stiff I had to use a pry bar to remove it. Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM