Gearchange issue?
#1
Scooby Regular
Thread Starter
Join Date: Sep 2006
Location: R.I.P. R.A. :(
Posts: 4,019
Likes: 0
Received 0 Likes
on
0 Posts
Gearchange issue?
This afternoon I noticed my gear lever is now only sprung-loaded on the right side...... (Subaru quickshift)
I had the gaiter off but can't see anything.... anyone help as it's making down shifting a slight pain...
Thanks in advance
I had the gaiter off but can't see anything.... anyone help as it's making down shifting a slight pain...
Thanks in advance
#2
There is a centering spring under the lever to the side of the gearbox that bias' the lever to 3rd/4th plane
They can corrode/fall off. You need to get right under the car to check. It is connected to a 60mm or so washer that traps the large stabilising rubber bush on the box just where the prop shaft enters the box.
If that is in place then i 'think' ie not sure that there are 2 detent springs/***** that are sometime liable to break so loosing the precision of the box.
Best guy to ask/fix it is David at Welcome to the API website
Graham
They can corrode/fall off. You need to get right under the car to check. It is connected to a 60mm or so washer that traps the large stabilising rubber bush on the box just where the prop shaft enters the box.
If that is in place then i 'think' ie not sure that there are 2 detent springs/***** that are sometime liable to break so loosing the precision of the box.
Best guy to ask/fix it is David at Welcome to the API website
Graham
Thread
Thread Starter
Forum
Replies
Last Post
Phil3822
General Technical
0
30 September 2015 06:29 PM