Front wheel bearing....easy?
#1
Front wheel bearing....easy?
Hi, the front near side wheel bearing on my 99 classic turbo needs replacing and i just wondered whether it was an easy enough job?
I have replaced a good few bearings in the past but never on a scooby, just wondered whether there was any special tools ie presses that i needed to carry out the job?
Oh and any suggestions for a place to buy the replacement?
Thanks in advance.
Dave.
I have replaced a good few bearings in the past but never on a scooby, just wondered whether there was any special tools ie presses that i needed to carry out the job?
Oh and any suggestions for a place to buy the replacement?
Thanks in advance.
Dave.
#2
Scooby Regular
Join Date: Feb 2003
Location: Zed Ess Won Hay Tee
Posts: 21,611
Likes: 0
Received 0 Likes
on
0 Posts
honestly
NO
a lot of them tend to heat up when worn and weld themselves to various parts, a lot of them dont make much noise either so they can go undetected for a long time
better to pay somebody to swap em IMO, just like i did, and it turned out mine was a ******* as well to get out
NO
a lot of them tend to heat up when worn and weld themselves to various parts, a lot of them dont make much noise either so they can go undetected for a long time
better to pay somebody to swap em IMO, just like i did, and it turned out mine was a ******* as well to get out
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM