Adding 440's before a re-map??
#1
Scooby Regular
Thread Starter
Join Date: Jan 2001
Location: Down South to Ooop North to Back Down South again!!
Posts: 6,633
Likes: 0
Received 0 Likes
on
0 Posts
Adding 440's before a re-map??
Will adding 440 injectors prior to getting a re-map really screw up the running of the car or will it run the same but with that extra bit of room for fuelling when I come to map it?
Cheers
MAFFA
Cheers
MAFFA
#2
Scooby Regular
iTrader: (1)
Join Date: Oct 2001
Location: South East
Posts: 1,300
Likes: 0
Received 0 Likes
on
0 Posts
it will probably run. bit lumpy and crap. depends how many miles you've gota do.
it only an hr (MAX) to change them. bit crap at the side of a road, freezing your nuts off tho!
Turning fuel pressure down a bit may make it better - if you can adjust it !
if you're gona put a mappable ECU in before you set off, you could adjust fueling down too, but then you'll still be running an unmapped car.
I'd leave it till you get it mapped. test fit them and check they dont leak etc. and then do it on the day.
Steve
it only an hr (MAX) to change them. bit crap at the side of a road, freezing your nuts off tho!
Turning fuel pressure down a bit may make it better - if you can adjust it !
if you're gona put a mappable ECU in before you set off, you could adjust fueling down too, but then you'll still be running an unmapped car.
I'd leave it till you get it mapped. test fit them and check they dont leak etc. and then do it on the day.
Steve
Thread
Thread Starter
Forum
Replies
Last Post
oilman
Trader Announcements
15
01 October 2015 11:55 AM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM