600Bhp on standard rods and crank?
Thread Starter
Scooby Regular
Joined: Mar 2003
Posts: 938
Likes: 0
From: Derby
600Bhp on standard rods and crank?
I went to a well known parts dealer/suplier on thurs and enquired about some forged pistons, rods an crank for a 2.5 block as i am considering going upto 600Bhp. I was informed that the standard rods and crank can take 600Bhp Surely this cant be right?
Last edited by DaveBlueRA; Aug 24, 2004 at 03:46 AM.
Scooby Regular
Joined: May 1999
Posts: 2,637
Likes: 0
From: SSO2003 2nd, SSO2005 1st, SSO2006 2nd, TACC Rd4 5th 4wd: In my car ;-)
The crank should be fine, but 600bhp 0n the stock rods, and pistons, is optomistic, in the extreme.
IMHO, the stock EJ257 block isn't up to 600bhp/ XXXftlbs., reliably.
The liners are VERY thin, and I doubt they would take the pressures.
Mark.
IMHO, the stock EJ257 block isn't up to 600bhp/ XXXftlbs., reliably.
The liners are VERY thin, and I doubt they would take the pressures.
Mark.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM