Does a P1 Backbox fit on an MY01?
#2
Nick,
I posted something similar a while back, and I've seen another post on the subject since. There is a difference with the front hanger being turned 180 degrees and if I remeber rightly it's also slightly lower. I had a look at Power Engineering's website and they supply a different bracket with their backbox dependent on whether for pre MY00 or MY01 on.
Hope this is of help.
Mark P
I posted something similar a while back, and I've seen another post on the subject since. There is a difference with the front hanger being turned 180 degrees and if I remeber rightly it's also slightly lower. I had a look at Power Engineering's website and they supply a different bracket with their backbox dependent on whether for pre MY00 or MY01 on.
Hope this is of help.
Mark P
Thread
Thread Starter
Forum
Replies
Last Post
Sambob
Engine Management and ECU Remapping
41
27 November 2015 07:36 PM