magnex mid-section (with silencer) perfect fit for a MY98?
#1
In a thread about the magnex mid-section I could read this:
"I did have trouble with the front mounting bolts though, as they appeared to create too much preload on the springs, almost causing them to crash, when tightened up. I had to add washers to the shouldered step, on the thread, to effectively increase the clamping length of the bolts and reduce the preload on the springs. They still crush the springs quite a bit more than the std set up, so am keeping an eye on the joint to ensure no cracking of components takes place."
I thougth the fitting of the mid-section was very easy and there would be a perfect fit???
any comments welcome
ric
"I did have trouble with the front mounting bolts though, as they appeared to create too much preload on the springs, almost causing them to crash, when tightened up. I had to add washers to the shouldered step, on the thread, to effectively increase the clamping length of the bolts and reduce the preload on the springs. They still crush the springs quite a bit more than the std set up, so am keeping an eye on the joint to ensure no cracking of components takes place."
I thougth the fitting of the mid-section was very easy and there would be a perfect fit???
any comments welcome
ric
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM