-=uk99=-

hi all
my baby is in for a rebuild on tuesday
im going for the full monty
pistons
rods
bearings ex
knock link
lamber ? "fuel" mixture any way
fuel pump
oil pump
regulator
headers "when i get them"
does anyone have anyother recomendations heads ported cams valves / springs
i will be getting a tdo5 when i have ran her in and a FM too
any advice you can give will be grate
cheers
Trev
-=uk99=-

[Edited by -=uk99=- - 8/2/2003 8:07:53 PM]

-=uk99=-

already have full torox 48's on braided and coilovers
i intend to get a fm when i make some more dosh m8
should i get comp head gaskets ??
valve springs??
ill have a slow 1000 mile to find them while i brake her in
to arange turbo/fm/re map
still not shure wether to go bb turbo though
at what power will the block be pos needing a closed ver??
cheers
Trev
uk99

[Edited by -=uk99=- - 8/4/2003 12:29:24 AM]

Scoty

Injectors
Turbo Inlet
Brakes

(if you havent already got the above of course )

jonny gav

iTrader: (1)

have a word with Bob at BRDEVELOPMENTS about remapping your ecu

also a FMIC has to be your list too

a TD05 and your standard injectors are good for around 350bhp but your standard intercooler isn't!

tweenierob

Think he may have already said it johnny

Rob

jonny gav

iTrader: (1)

bugger

jonny gav

iTrader: (1)

harvey is running well over 400+bhp on an open deck for around 30k so i think you are safe

rapac

STi or s/s gaskets??
Head studs???
Lower compression if to run high psi??


Cheers