Custom Exhaust system?
#1
Scooby Regular
Thread Starter
Join Date: Feb 2001
Location: Hemel Hempstead
Posts: 7,953
Likes: 0
Received 0 Likes
on
0 Posts
Im looking to have a custom 3in exhaust stainless system made for my car over the nexy couple of weeks, I have a few companies in mind but thought I would ask you orrible lot anyway.
Im in Hemel Hempstead, Hertfordshire and would like the fabricator to be as close as possible.
Any thoughts?
Cheers
Paul
(Ive spoken to Haywood thanks.)
Im in Hemel Hempstead, Hertfordshire and would like the fabricator to be as close as possible.
Any thoughts?
Cheers
Paul
(Ive spoken to Haywood thanks.)
#3
Scooby Regular
Thread Starter
Join Date: Feb 2001
Location: Hemel Hempstead
Posts: 7,953
Likes: 0
Received 0 Likes
on
0 Posts
prob a bit too far for me cos im lazy ta anyway dude
[edited cos wot i rote didnt make any sense at all]
[Edited by POC - 1/30/2003 2:15:43 PM]
[edited cos wot i rote didnt make any sense at all]
[Edited by POC - 1/30/2003 2:15:43 PM]
Trending Topics
#10
Hi POC, if you do use them make sure they have the job done A1! look out for tacky welding, blowing, rattle which may be weld which has fallen into the baffle...that can be quite annoying...Rev it, listen, check through and through..These guys operate on a franchise basis.....Best to contact someone who has been recommended, and has done work to the spec you are looking for
Cheers
MOE
Cheers
MOE
#11
Scooby Regular
Join Date: Jul 1999
Location: Here and there...
Posts: 1,197
Likes: 0
Received 0 Likes
on
0 Posts
POC
Go for H&S mate I've just picked up my Scoobyworld Afterburner and the finish was lovely. It made my old H&S back box look poor in comparision!!
Go on, go on, go on!!!
Tim
Go for H&S mate I've just picked up my Scoobyworld Afterburner and the finish was lovely. It made my old H&S back box look poor in comparision!!
Go on, go on, go on!!!
Tim
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM