What bhp should I expect from these mods
23 April 2013, 09:16 PM
#1
Scooby Regular
Thread Starter
Join Date: Aug 2011
Location: Northampton
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
What bhp should I expect from these mods
Hi, I have a 2007 subaru sti hawk eye, I have the following mods, stainless steel cat back 3 inch exhaust - unbrandad
Aftermarket cone style air filter, dump valve and remapped by race Dynamix.. Standard bhp on this sti is 276. Can anyone advise me what they think the bhp should be on this now? As It feels down on power..I have the graph lying around somewhere and I'm just going to look for it
Aftermarket cone style air filter, dump valve and remapped by race Dynamix.. Standard bhp on this sti is 276. Can anyone advise me what they think the bhp should be on this now? As It feels down on power..I have the graph lying around somewhere and I'm just going to look for it
Last edited by smi2ml; 23 April 2013 at 09:18 PM.
23 April 2013, 09:31 PM
#3
No mods there to make a lot of difference to be honest. The dump valve adds nothing other than noise and you could even end up with less power than you started with if the cone filter's not up to much. A good remap on the standard car should take it to around 300bhp, however nothing is guaranteed.
24 April 2013, 09:23 PM
#5
Scooby Regular
Thread Starter
Join Date: Aug 2011
Location: Northampton
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post