I've got a 2003 blobeye saloon, and I need to adjust the rear coilovers but can't figure how the rear seats come out so I can gain access to them. Can anyone tell me, or better still, have a picture to show me etc.
I did try searching, but nothing really came up that would help.

Thanks.

 

Take the bench off first there are a couple of bolts where your legs would be holding them down then once you have un done them remove the bench you will ten see the bolts holding the back of the seat on I think there is 4 I can't remember undo then and just lift the seat and it will come out you will then see your suspension tops sorry if it sounds a bit vague but u will know what I mean when u look

 

As craig says, undo the two, or three bolts below the front face of the seat squab, lift, lift at rear and remove.

Low down there are now three more, undo those. You may now have to "knock" the rear seat upwards, as it's hooked over at the top.

Replacement is the reverse, ensure it's hooked over first etc..

 

What coilovers do you have? Might be worth investing in a set of adjusters like I have on my BCs, makes changing settings a doddle.

 

Coilovers are Hotbits DT1 fully adjustables from scooby clinic.

 

http://www.scoobyparts.com/acatalog/...ADJUSTERS.html

This is what I have, can change the settings without having to remove the rear bench, not sure if there is a similar product for your ones.