Guys the instuctions were a bit vague when installing, so i want to use the 3rd port on the BCS but not sure where to plumb/T it into?



Iv got one to the actuator vacuum (as per instructions)
Iv got one to the dump valve vacuum (pre-tb instructions said)

Where does the 'normally closed' port need to attatch to?

Thanks
Jon

 

Either leave it open, as in the picture or plumb it back into the inlet pipe between the maf and the turbo inlet

 

im just wondering if iv done it completely wrong

should one go to the actuator, then one to the compressor housing? third to the inlet tract?

arrr

 

COM to actuator
NO to compressor
NC to inlet or VTA.

 

doh

Thanks Andrew!