AVCR - quick q regarding 3 port
28 September 2009, 09:04 PM
#1
Scooby Regular
Thread Starter
iTrader: (33)
Join Date: Jul 2007
Location: E Yorks
Posts: 4,791
Likes: 0
Received 0 Likes
on
0 Posts
AVCR - quick q regarding 3 port
Guys the instuctions were a bit vague when installing, so i want to use the 3rd port on the BCS but not sure where to plumb/T it into?
Iv got one to the actuator vacuum (as per instructions)
Iv got one to the dump valve vacuum (pre-tb instructions said)
Where does the 'normally closed' port need to attatch to?
Thanks
Jon
Iv got one to the actuator vacuum (as per instructions)
Iv got one to the dump valve vacuum (pre-tb instructions said)
Where does the 'normally closed' port need to attatch to?
Thanks
Jon
28 September 2009, 09:18 PM
#3
Scooby Regular
Thread Starter
iTrader: (33)
Join Date: Jul 2007
Location: E Yorks
Posts: 4,791
Likes: 0
Received 0 Likes
on
0 Posts
im just wondering if iv done it completely wrong
should one go to the actuator, then one to the compressor housing? third to the inlet tract?
arrr
should one go to the actuator, then one to the compressor housing? third to the inlet tract?
arrr
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM