Just a quick one,

I'm after a hydraulic press. Is a 10 tonne press good enougth for pressing out stub axle's & wheel bearing's?

Dont wanna buy one and it not do the job.

Cheers

Craig

 

Come on some of you guys must own this type of equipment.

I thought this would of been answered in 2 secs.

Craig

 

TBH mate i bet most peeps dont know how powerful their press is?

I would have thought 10 tonne would have been more than adequate. I will check mine tom and post the rating, it hasn ever failed to pop whatever bearing or bush i have thrown at it

Mike

 

Easy good enough.

 

That would be top.

Cheers

 

Hi mate, I bought a 20 ton bottle jack style one of fleebay a few month ago, an excellent bit of kit. I did a front and rear wheel bearing with no problems, it was about 150 if I remember rightly including postage. It was heavy at about 100 kilos, I will look out the ebay link and pm you tonight.

 

Cheers guys,

I'll prob go with a 10 tonne one, the general consensus is that it will be fine.

Craig