What pressure to set the SX FPR to?
Thread Starter
Scooby Regular
Joined: May 2004
Posts: 11,341
Likes: 1
What pressure to set the SX FPR to?
I've fitted a new FPR to my Sti v3. I want to run the car to clear all the greases etc off ready for an Apexi FC to be fitted.
The car has also a Walbro pump and 550cc injectors and the stock Sti v3 ECU.
Just to get it running to move the car out of the garage, what pressure should the SX FPR be set at?
911
The car has also a Walbro pump and 550cc injectors and the stock Sti v3 ECU.
Just to get it running to move the car out of the garage, what pressure should the SX FPR be set at?
911
Subaru Tuning Specialist
Joined: Jun 2002
Posts: 6,654
Likes: 1
From: 7.74 @179 mph 1/4 mile - road legal
The Sti is changing from 440's to 550's. If you set it to 2.0 bar at atmospheric then it will be in the ball park for running it, closed loop control will manage to catch it once warmed up (off boost only)
Andy
Andy
Thread Starter
Scooby Regular
Joined: May 2004
Posts: 11,341
Likes: 1
Thanks to both.
will set it to 2 bar with the vac pipe off.
Set at 3 bar at the moment to check for leaks, all ok (!)
Andy, have you found my email on a mapping date? (your hotmail address)
Graham.
will set it to 2 bar with the vac pipe off.
Set at 3 bar at the moment to check for leaks, all ok (!)
Andy, have you found my email on a mapping date? (your hotmail address)
Graham.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM