I am fitting a boost gauge and oil temp gauge to my 94wrx, can someone help me with some pics maybe of where the vacuum pipe is for the turbo and where the temp sensor goes for the oil?

any help would be much apreciated

thanks madjust

 

Have a look at www.chiark.co.uk
Also, oil temp is usually taken via the blanked off tapping on top of No.3 cylinder, which is at the rear of the engine, o/s.
You can see the blanking plug, which has an 8mm allen key hole in it, if you look down in front of the intercooler, but removing i/c makes it easier to see and get at. You'll need a LONG 8mm hex key, and an adaptor for whatever sender you have, probably best bought from wherever the gauges came from.

The boost gauge on mine was taken from an unused outlet (inlet?) on the front n/s of the inlet manifold, on my '98 UK car it had a rubber sleeve over it.

Alcazar

 

thanks mate. the only problem is the pics and descriptions are of the facelift version but i presume they must be similar

 

Just as a side note, the oil temp on my car is done in the sump, the sump nut is now and adapter for the sender, i dont think it matters hugely where the temperature comes from, you just have to get used to what an ideal oil temperature when warm is for your car and then not push it until its nice and warm

 

ANYONE ELSE GOT THE PICS FOR A PRE FACELIFT MY94 WRX?

 

try http://www.mudd90.freeserve.co.uk/home.htm

 

thanks all you guys i am very confident with what im doing now.


Thanks again

Mad just