Lamdalink installation
Scooby Regular
Joined: Dec 2000
Posts: 2,912
Likes: 0
It works with the factory sensor, connect the lambdalink to the wiring harness at the ecu.
You're looking for a white wire in the 2:nd row from the bottom of the blue connector.
Wjile you're at it, nick +12VDC from one of the yellow/blue (2 thicker leads going into the top row, on the left), ground it on the lower bolt that holds the ecu package.
And most important...
No scotchlocks, SOLDER everything.
/J
You're looking for a white wire in the 2:nd row from the bottom of the blue connector.
Wjile you're at it, nick +12VDC from one of the yellow/blue (2 thicker leads going into the top row, on the left), ground it on the lower bolt that holds the ecu package.
And most important...
No scotchlocks, SOLDER everything.
/J
Thread
Thread Starter
Forum
Replies
Last Post
