Alternator belt & 3 pulleys?
Can someone tell me what the 2 other pulleys are attached too on the alternator belt (3rd one being the alternator itself)?
I assume it's job is just to turn the alternator keeping the battery topped-up whilst the car engine is running?
Stefan
I assume it's job is just to turn the alternator keeping the battery topped-up whilst the car engine is running?
Stefan
Scooby Regular
Joined: Nov 2001
Posts: 15,239
Likes: 1
From: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?
Crankshaft pulley.. centre bottom..
Left Hand side Power steering pump..
If you have another belt from crank to the right then aircon pump..
HTH
David
Left Hand side Power steering pump..
If you have another belt from crank to the right then aircon pump..
HTH
David
David,
I take it there's no markings or anything involved. Just as long as the belt is on each pulley correctlty and tension to between 45 & 90 degrees it's fine?
Only reason I ask is I had the alternator off last night and just wanted to check I've not missed something important.
Stefan
I take it there's no markings or anything involved. Just as long as the belt is on each pulley correctlty and tension to between 45 & 90 degrees it's fine?
Only reason I ask is I had the alternator off last night and just wanted to check I've not missed something important.
Stefan
Scooby Regular
Joined: Nov 2001
Posts: 15,239
Likes: 1
From: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?
if it doesnt squeak the it will be ok 
should be able to twist the belt 45- 90 degrees as you say..
Check tensioner is bolted up properly..
David

should be able to twist the belt 45- 90 degrees as you say..
Check tensioner is bolted up properly..
David
Trending Topics
aye, I saw that the other day. Your either a brave man or know what your doin. Hopefully you'll never have to do that again.
Any ideas what caused it? was it the timing belt being out of alignment?
Stefan
Any ideas what caused it? was it the timing belt being out of alignment?
Stefan
I reckon its a combination of the timing out & the fact the ECU had a Jap aftermarket chip which up'd the boost and was mapped to 100RON+, over time the car's been det/knock and I've not known, then BANG.
It won't happen again, I'll be gauged to the max & uprated metal to make sure it doesn't go BANG in my lifetime.
It won't happen again, I'll be gauged to the max & uprated metal to make sure it doesn't go BANG in my lifetime.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM




