Hi all
I have just come across a company that make steel mesh filters, if I could persued them to make PANEL FILTERS, would this be an end to concernes over MAF sensors and FOAM/Oiled filters.
Just think performance filter in your standard air box, Air flow sensor safe.....
Your thoughts would be nice
Lanky

 

Can the steel filter down to the same level as a foam/cotton filter? Although there is going to be less oil/cack getting to the maff is there likely to be more general dust getting into the engine?

 

just dont even think about it!

 

Subaru have a recommended limit on "hole" size they expect in air filters .. its pretty small, like 10 micron ( some one correct me if I am wrong please).

After market filters struggle to meet this, and those stainless filters liker the Blitz cone have 180 - 200 micron holes IIRC... so not a good idea?

Your choice tho, as always....


[Edited by vulnax999 - 7/22/2003 2:30:05 AM]