1998 saloon.
It's on a long term repair/ renovation and they are close to rebuilding.
But we can't remember how the two assymetric steel brackets fit that support the two alloy brackets which in turn support the rear of the bumper at the front wheel arch.
Does anyone have access to diagrams, pics or owt that might help.
TIA

 

 

Thanks Don, seen that, but not enough detail.

 

Ahy photos of the brackets you mentioned???

 

Must be number 11 Don I'm pretty sure they clip in.

 

Will get some tomorrow. It's at a bodywork place about ten miles off.

 

Slightly better image



Looking up from below

 

Sorted, thanks.
We were short one slide bolt, one of each fits into the two vertical handed alloy brackets.
Once I pointed out where they went, and we located the missing one, we worked out where the two steel brackets went, which was easy enough since their captive bolts were in entirely different places.
It's back together now with the bumper refitted.
Might actually have it back by the end of the month🙂