Does anyone know if the angle that these come out on can be adjusted?


When my drivers side one is closed there is a slight gap visible between the washer cover and the hole in the bumper


Thanks

Ade

 

They are on a fixed bracket so I doubt it , however the tops are attached by 2 screws.
Possibly mis aligned or loose . It's just a suction push that forces them upwards , so if you ( gently get a flat knife under ) then pull it upwards you will be able to see if the top is slack . If so you need a very small Phillips to tighten . Other wise it's bumper off , as I suspect the washer stork bracket tab has snapped or cracked ... Hope this gives some clarity

 

Anyone know where I can get a right hand side unit my m8 has lost his

 

I gather he just needs the top cover ^

I took my whole system off after the (Asda ) incident .
There in the garage boxed up somewhere 02c
1 top has a chip in it ( not sure wich at hand
If you wish me to look for you no probs

 

Drivers side ( right ) as requested