So the upipe is part of the headers and doesn't separate, and I can't for the life of me see how to get the up pipe through the engine bay with it attached to them. Anyone ever fitted or know how it can be done? Before anyone starts, I know they're cheap etc if you're going to comment and say I need to buy some others then don't bother. Thanks.

 

Hi mate use an engine brace and lift on the engine mounts a little not to much tho this should allow you to get it in there I had a bit of a mere getting my uppipe in as well hope this helps :-)

 

Got mine on, but was using mates ramp, pain of a job

 

Not sure if it will give enough clearance but undo the engine mount nuts on the front subframe. You may have to move the ARB to get to them. Then jack the engine up a bit. Once its up wedge something between the engine mounts and subframe (thin bit of wood) to keep it up. The higher you go the more room you will have. Beware if you go more then an inch or so the engine mount bolts will pop out of the subframe and take some wiggling to get back in.

Make sure as you jack you don't tear any hoses or wires.