The Bomber... a different dimension
#66
Scooby Senior
iTrader: (51)
Join Date: Nov 2005
Location: Wherever I park my car, that's my home
Posts: 20,491
Likes: 0
Received 2 Likes
on
2 Posts
Having seen this in the flesh this weekend I am now going to pull my finger out and get my engine bay sorted. Got some ideas from yours and a few others for some little 'custom' tweaks on mine.
Yours is a stunning motor though
Yours is a stunning motor though
#68
Scooby Senior
iTrader: (51)
Join Date: Nov 2005
Location: Wherever I park my car, that's my home
Posts: 20,491
Likes: 0
Received 2 Likes
on
2 Posts
I'm going to fabricate some sort of paneling for the inner wing - slightly different to your moulded one as my intercooler pipe runs though there too. I'm putting my PSI3 on to the dash top so I'm looking at options for gauge mounting and you vent set-up is tidy which I might play a tune on rather than go down the a-pillar route.
Some of the simpler stuff I saw were the OE recirc brackets fixing them to the inlet and an improved pipework bracket onto the inlet - the difference between the Perrin and Japspeed stuff in terms of that last 5% is quite marked. In all it's just going to be a case of de-cluttering under the bonnet as best I can, oh and fitting my extra bonnet vent - slightly different to your but I like the way you had the threads fitted for your winter weather proofing
With getting my MSc just about in the bag and back to a 9-5 job I'm looking forward to just having the time to get bits done.
Some of the simpler stuff I saw were the OE recirc brackets fixing them to the inlet and an improved pipework bracket onto the inlet - the difference between the Perrin and Japspeed stuff in terms of that last 5% is quite marked. In all it's just going to be a case of de-cluttering under the bonnet as best I can, oh and fitting my extra bonnet vent - slightly different to your but I like the way you had the threads fitted for your winter weather proofing
With getting my MSc just about in the bag and back to a 9-5 job I'm looking forward to just having the time to get bits done.
Thread
Thread Starter
Forum
Replies
Last Post