Originally Posted by scoobymods

good thread on drivetrain!!!

posted by Andy-F

"There are a number of issues to consider when using a VTA or blanking off the OE recirc valve.
VTA (and recirc) DV's come in a range of opening pressure settings. Whether high or low pressure, with a VTA there can be issues.

1 - Overfueling due to excessive venting to atmosphere
2 - Stalling the turbo
3 - MAF revertions and System volume
4 - Repressurisation time
5 - High pressure damage


Looking at the issues one at a time,

1 - Overfueling due to excessive venting to atmosphere

If you run a standard pressure vent to atmosphere dump valve (BOV, VTA, Atmo DV) with a mass air flow monitoring ECU such as the OE Subaru, then you can have problems when the DV opens under cruise conditions. The DV allows air to escape from the system during the high vacuum conditions during cruise, The reason for this is the signal side of the DV is subject to vacuum and the flow side is subject to slight boost pressure (the difference across the throttle valve) If this exceeds the spring pressure then the valve starts to vent.
This airflow has been monitored by the ECU and fuel is added accordingly, the result is too much fuel for the air being consumed by the engine.
Best case - You just waste fuel but who cares when you get that 'pschhhht' you've always wanted
Worst case - You cause bore wash, increase oil consumption and reduce engine life.


2 - Stalling the turbo

The term turbo stall refers to stalling the airflow across the compressor blades, not physically stalling the rotor (common misconception)
This is a case of what happens if you don't use any DV or use a valve with too strong a spring.
When you lift off the throttle on full boost, the compressed air has no where to go and blasts back across the blades giving that (lovely ) sharp 'cacho' or WRC chirp as some call it. Very taxing for the turbo, all this backwards flow.
Best case - Runs forever (TD series generally tougher than VF series)
Worst case - Shatters compressor wheel or thrust bearing fails


3 - MAF revertions and system volume

This is not such an issue with a TMIC but when FMIC's are used the system volume is so large that when the throttle is brought back from power (boost) to cruise, if a strong spring DV is used (strong enough to eliminate issue 1 ) then you can get a sudden pulse of pressurised air back out of the MAF, this is measured as an airflow (the meter can't differentiate) and the engine overfuels giving a hicup/jolt
Best case - Slightly jerky drive as you come off throttle
Worst case - Very jerky !


4 - Repressurisation time

This is where the stiff spring DV or running without DV scores a point. The system holds more pressure between gearshifts as the DV isn't venting it. Boost recovery in the next gear is improved (slightly)
Best case - Improved response after a gearshift
Worst case - Issues 2 and 3 above.


5 - High pressure damage

If you use no DV or a high pressure DV spring then when the turbo is spinning at high speed and the throttle valve is snapped shut, there is a pressure pulse in the system
which can be high enough to damage the intercooler etc.
Best case - At boost below 1.5 bar you will probably be ok
Worst case - Bigger turbo's/ higher boost may pop hoses off or 'balloon' the intercooler core.

Options ?

A light pressure recirc valve (just like std) overcomes all of the above issues but sounds a bit boring "

glad i gone back to recirce dump valve now

scoobymods

Originally Posted by colby

Byrn i bet u are please u took my advice now !!!!!

Originally Posted by Mark320STI

where u meeting

Originally Posted by colby

god dam

my car had to rebooted again to restart the engine again

must be fault on power lead from battery