Just got a set to upgrade the standard ones, but just have a quick question on where the best place would be to fit an Earth connection, see pic below for a choice:-
Thought maybe here under the bolt?

or in this hole arrowed?

Just for info, the new horns have a 2 slade connection, where as the standard ones only have one, so a 1/4" female slade connector is needed, as explained in the instructions.

 

Darren iv fitted these to mine & all i did was to open up the connector a little & fit as your top picture

 

Always meant to upgrade the horn, but never got round to it.

Hardly use it anyway, and i doubt it would be heard over the exhaust.

 

Fitted them today, dead easy aren't they! weren't too sure if you had to earth each one seperatley, did anyway:-


Shame you can't see them much through the grille

 

Exactly the same place and fiting as mine.....

They sound 1000 times better than the OE one dont they!!

Andy

 

Bit of a thread revival ..... just fitting a set of these to my car, how did you get on fitting the second horn behgind the headlight? Its a bit tight for space and the horns are pressed up against the bumper, the one behind the headlight is at a bit of an angle when I try to do it ...... ?

 

Think mine both sat at an angle really, and low down.
Can't 100% remember how the headlight one went, must have been easy, maybe just a fiddle, grille come off to give a bit more room for you to hold the horn and do the nut up.

 

still working 2 years on?

 

Oh Yes, good buy they were.

 

cool thanks mate