PIAA Sports Horn
 

Just got a set to upgrade the standard ones, but just have a quick question on where the best place would be to fit an Earth connection, see pic below for a choice:-
Thought maybe here under the bolt?
http://i18.photobucket.com/albums/b1...tickers015.jpg
or in this hole arrowed?
http://i18.photobucket.com/albums/b1...tickers016.jpg
Just for info, the new horns have a 2 slade connection, where as the standard ones only have one, so a 1/4" female slade connector is needed, as explained in the instructions.

Darren iv fitted these to mine & all i did was to open up the connector a little & fit as your top picture :)

Always meant to upgrade the horn, but never got round to it.

Hardly use it anyway, and i doubt it would be heard over the exhaust. :D

Fitted them today, dead easy aren't they! weren't too sure if you had to earth each one seperatley, did anyway:-
http://i18.photobucket.com/albums/b1...AAhorns003.jpg
http://i18.photobucket.com/albums/b1...AAhorns001.jpg
Shame you can't see them much through the grille
http://i18.photobucket.com/albums/b1...AAhorns002.jpg

Exactly the same place and fiting as mine.....

They sound 1000 times better than the OE one dont they!!

Andy

Bit of a thread revival ..... just fitting a set of these to my car, how did you get on fitting the second horn behgind the headlight? Its a bit tight for space and the horns are pressed up against the bumper, the one behind the headlight is at a bit of an angle when I try to do it ...... ?

Think mine both sat at an angle really, and low down.
Can't 100% remember how the headlight one went, must have been easy, maybe just a fiddle, grille come off to give a bit more room for you to hold the horn and do the nut up.

still working 2 years on?

Oh Yes:thumb:, good buy they were.

cool thanks mate