Dumb caliper seal silver clips!
#1
Scooby Regular
Thread Starter
Join Date: Mar 2019
Location: Herefordshire
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Dumb caliper seal silver clips!
Annoying clip!
Anyone got a top tip for making these stay on? I put them on, hold them there, let go and they flippin slip right off again!
#2
THE braking specialist
iTrader: (259)
Hi
Yes they can be little buggers lol.
You need to make sure the dust boot , inside and out , and the lip on the caliper casting they sit on , is completely free of grease , when we build them up , we use rubber grease to fit the pistons , locate them most of the way , clean off any excess grease , fit the dust boot to the piston , push the piston in the final amount , then push the dust boot onto the caliper , and fit the clip , doing it this way , it will stay on
Hope this helps
Cheers Ian
Yes they can be little buggers lol.
You need to make sure the dust boot , inside and out , and the lip on the caliper casting they sit on , is completely free of grease , when we build them up , we use rubber grease to fit the pistons , locate them most of the way , clean off any excess grease , fit the dust boot to the piston , push the piston in the final amount , then push the dust boot onto the caliper , and fit the clip , doing it this way , it will stay on
Hope this helps
Cheers Ian
#3
Scooby Regular
Thread Starter
Join Date: Mar 2019
Location: Herefordshire
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Thanks godspeed, that's what I ended up doing, I sanded the inside of the clips a little too to give them some grip, I've ended up pinching the seals a bit is it going to cause problems?
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
General Technical
0
03 March 2018 09:36 AM
The Rig
Wheels, Tyres & Brakes
3
01 July 2010 11:41 PM
Godspeed Brakes
Trader Announcements
1
05 April 2010 08:14 PM