Car not starting after changed clutch line
#1
Scooby Regular
Thread Starter
Car not starting after changed clutch line
Hi any ideas why my car won't start it's a jdm blob so have to push clutch down to start fit started after I replaced clutch line for a braided one , when it wouldn't start I replaced the slave cylinder and bled it could there be air in system still the pedal feels good untill about 3/4 up then it springs back
Trending Topics
#11
Scooby Regular
Thread Starter
I put a multi metre on the battery and it had 12.6v then turned ignition on and was 11.7v does this sound ok
Last edited by seanvx; 08 April 2018 at 01:22 PM.
#14
Scooby Regular
Thread Starter
Went to crank it and it stayed at 11.7v , could it be I had an alarm fitted last week toad one thing is I don't try start it all week so not sure when it stopped starting but iv tried everything it must be the alarm
#20
Scooby Regular
Thread Starter
Anyone know where I can find wiring diagrams or could tell me what these plugs do , the alarm fitter said someone has had a alarm fitted before but made right mess of it
These 2 are by the bonnet release and when I plug them in I get a constant beeping
These 2 are by the bonnet release and when I plug them in I get a constant beeping
#21
Scooby Regular
Thread Starter
These are with the 2 green diagnostic clips there is a small male one at highest then below next to diagnostic ones is 2 small black male ones and a larger white male one the car is a 53 jdm Impreza sti with central locking extra
#23
Scooby Regular
Thread Starter
Yer tried that it's constant weather door open closed ignition on etc , it's such a mess , alarm fitter useless need try fix this he said alarm working as it should he saying something wrong with the car
#26
Scooby Regular
iTrader: (1)
Join Date: Apr 2005
Location: In the Flatlands of Lincolnshire
Posts: 2,892
Likes: 0
Received 0 Likes
on
0 Posts
loosen the starter motor and rock it or put the car in gear and rock back and fore. If you hear a clunk then the starter pinion gear was stuck in the flywheel. As you say the lights dim when trying to crank the engine says to me the starter is engaged. This puts the highest load on the battery thus dimming the lights.
#27
Scooby Regular
Thread Starter
Not had time to look into this further , will do at weekend but would a failed neutral position sensor cause it to not start I was told it was failing about a year ago
#29
Scooby Regular
Thread Starter
Right I had a look all fuses seem good I checked the power going to the starter and there was nothing 0.02v all cables running of it seem good to any ideas where I go from here
#30
Scooby Regular
Voltage to the solenoid with ignition key in start position?? (otherwise it will be zero)