Prodrive PFF7 centre cap sizes
#6
18 June 1815 - Waterloo
iTrader: (31)
Trending Topics
#10
I've ordered some caps off these chaps, and then I'll get some gel stickers to go on them. I've gone for a 60mm/55.5mm set and see how I go. Otherwise, they do a 59mm/55mm set. It's only 7 quid, so I'll give it a bash.
http://ej-parts.co.uk/category/wheel...Center%20Caps/
http://ej-parts.co.uk/category/wheel...Center%20Caps/
#12
Had the centre caps delivered today along with the gel stickers and result! Fit is very good. So, if you want pff7 centre caps it is 60x55.5 from above company, and use a 60 mm gel sticker. Although the cap would probably also take a 59 mm sticker as this the dimension on the spec sheet. I'll have a look at the fit from behind once I have the wheels off, but on first look it seems secure.
Full spec
Old cap
New cap
Side by side
Full spec
Old cap
New cap
Side by side
Last edited by sprigeteer; 24 October 2017 at 06:14 PM.
#15
Scooby Regular
iTrader: (1)
Had the centre caps delivered today along with the gel stickers and result! Fit is very good. So, if you want pff7 centre caps it is 60x55.5 from above company, and use a 60 mm gel sticker. Although the cap would probably also take a 59 mm sticker as this the dimension on the spec sheet. I'll have a look at the fit from behind once I have the wheels off, but on first look it seems secure.
Full spec
Old cap
New cap
Side by side
Full spec
Old cap
New cap
Side by side
#17
Scooby Newbie
I'd like to find similar ones but for the 18" PFF7's. Apparently these are different size?
The following users liked this post:
#19
Scooby Newbie
I’ve just my centre caps for my PFF7’s, just bought universal flat caps and gel stickers to put on them, I think they look good 👍
The size I got were 59 mm outer with a 55mm inner clip diameter. I had to file them down slightly as I think the powder coat is quite thick but they fit ok 👍
The sticker diameter I got was 60mm.
The size I got were 59 mm outer with a 55mm inner clip diameter. I had to file them down slightly as I think the powder coat is quite thick but they fit ok 👍
The sticker diameter I got was 60mm.
#20
Scooby Newbie
Links to caps and stickers I used 👍
caps:
https://ej-parts.co.uk/wheel-center-...f-4-four-caps/
stickers:
https://www.etsy.com/uk/listing/6905...xoCPRIQAvD_BwE
caps:
https://ej-parts.co.uk/wheel-center-...f-4-four-caps/
stickers:
https://www.etsy.com/uk/listing/6905...xoCPRIQAvD_BwE
The following users liked this post:
#22
Scooby Regular
iTrader: (4)
Hi all. This is the prototype, printed in pla plastic, knocked up from csf's measurements. It fitted first time which was a pleasant surprise!
The proper ones would be in PETG which is a bit more robust material and I could do different logos. I'd suggest they be painted too.
The proper ones would be in PETG which is a bit more robust material and I could do different logos. I'd suggest they be painted too.