Any one runninga 2.5 fully forged engine with inserts
 

As above im about to put one in my classic with supporting mods for 500+.What im wondering is anyone else on here running this setup and how much power they can handle safely so i can decide on maps. Any help appreciated cheers

Speak to Alyn @ASperformance mate he will answer your questions on this

Martin

Hi gav


You will require a gt3076 std position,, I have one for sale,, £800
750cc injectors
Larger intercooler
255 lift pump
044 Bosch fuel pump
272 cams will help
Avcs heads will give getter low torque
Run boost at 1.8 bar,, you will be fine with the inserted block
I was running 1.5 bar on ok'd engine with no inserts, at 487 bhp




I have just put one in mine,
I have used Arrow RCM rods
Omega RCM pistons
14mm head bolts
11mm RCM modified oil pump
Ported avcs heads with one piece valves 272 lateral cams
RCM rotated twisted kit
GT spec 3 bolt rapped headers
Owen development HTA3586 billet turbo
Tial 44mm external waste gate
Using a spec c rotated front entry inlet manifold
2000cc ID injectors
Bosch 044 lift pump
Twin Bosch 044 pumps running to parallel fuel rails
4 port direct Nos injection
Using 40% Vpower
40% meth
20% Toulon
Not pushing for massive power but wanting got torque
Hoping for about 650bhp and just a bit more torque

Engine gets started this week
Testing in 2 weeks
sprints at the end of the month

I will let you know if it goes bang

Hope this Helps

Bez