Installing Sigma S30 alarm
 

Im thinking about installing the sigma s30 cat 1 alarm to my car.
Would any one know where is the best place to run the wires to. eg colour and location
Its for a 1995 impreza WRX

for it to be any use insurance wise it needs installing by a qualified installer and then they issue you with a certificate for the insurance company.

even with a Certificate of installation ?

well if your qualified to install you wouldnt be asking simple questions on how to fit it.

as above..i wouldnt go for sigma 30 either....

auto watch all the way

Auto watch is that better than sigma s30 ?
And my point is i dont want a simple install which is why i asked where would be the best pace to run the wires to so it make it hard to get around.
I dont see the point in paying some one £150 on instalation when i can do it my self.
I have rebuilt cars from scratch worked for AA, RAC and green flag. Fitted a cat 1 alarm to my old MR2 which i stripped the whole interior to fit because i knew which wires i was heading for.

Tbo no disrespect but if u have done what u say u want people to tell u what wires and where then it will be open to everyone where u tap into them
if u are up one electrics its easy to find what u are after with a multimeter
like i say no disrespect but understand how this sounds
Regards Ian

I was only after a few tips on where to aim for that would be a good place to run the wires.
and i really didnt expect people to post it on here was thinking more on the lines of a pm.
i have got to get a new multimeter though before i start doing it.
iv been looking at the autowatch and they do seem better. i like that it has a turbo timer built in as well