Bugeye Ecutek
 

Hi all

On my bugeye it has a map to run high boost and low boost by putting your foot on the gas and holding the rear de-mister button to select maps. I took the bugeye out for a spin earlier, however the high boost map dont appear to be working. Could this be anything to do with the fact that my bugeye had a flat battery for about 2 weeks.

Anyone got any ideas??

Can you re-install a map with any software mapper or do you have to go back to the original place?

The map certainly wouldnt have been lost from a flat battery. Although it may default to the low boost map. Should just be a case a switch back as youve desribed once the battery is charged

you may have also wipped any learning the ecu has done. It will re learn as you drive

Sounds like the perfect reason to fill up n go for a spirited drive then lol