Boost leak test Help
Ok I still have boost leak ... I posted a thread a while ago but still have not sorted it as it seems impossible to find. So my question is and this is compleatly new to me but I can hear the leak once I hit about 1. / 1.1 bar Soooo do I just remove the air intake pipe put a bung with valve into the turbo intake at the maf end and pressurise the system up to 20 psi IS THIS SAFE & is this posible I really have no Idea :(
Many thanks in advance for any help. :notworthy |
Try this stuff mate
http://www.swagelok.com/products/lea...-detector.aspx Use it at work amazing stuff! |
Originally Posted by 99mrbe
(Post 10873894)
Try this stuff mate
http://www.swagelok.com/products/lea...-detector.aspx Use it at work amazing stuff! How dose it work bud ?? |
It's A clear liquid which you pour on all pipes and joints!
When you rev the engine you create enough + pressure! If there's a leak it will blow bubbles like at a foam party! We Use it on aircraft, very good stuff! |
Originally Posted by 99mrbe
(Post 10873909)
It's A clear liquid which you pour on all pipes and joints!
When you rev the engine you create enough + pressure! If there's a leak it will blow bubbles like at a foam party! We Use it on aircraft, very good stuff! Thanks buddy will bare this in mind :thumb: But am really tring to find out the best way off pressurising the system safely. .. Many thanks again |
If I had a ruff idea where the leak was coming from I'd be using ur stuff for sure but ATM I have no idea :(
|
No worries pal! With pressurising the system, I wouldn't like to say! A non turbo car yea fine to find cracks in Manifolds etc! But wouldn't like to say yes and blow up your car!
|
Originally Posted by 99mrbe
(Post 10873894)
Try this stuff mate
http://www.swagelok.com/products/lea...-detector.aspx Use it at work amazing stuff! |
Originally Posted by JohnnyBlaze
(Post 10873978)
Can you not just use soapy water in a spray bottle?
Tried it :( and cannot find it :cry: Need to pressurise the system to find leak :thumb: |
Ok mate, make ur own tester it's all the rage on nasioc, I was reading about it on there just the other day
|
That's what I'm trying to do ... I've just ordered some valves via eBay but I'm just need to understand what I have to do... Ie what points I pressurise from and if I need to blank any point off to close the system off and if 20psi is safe
|
What blow off valve have you got?.
|
Originally Posted by johned
(Post 10874179)
What blow off valve have you got?.
|
I would put the standard re circ one back on mate, you'll probably notice an improvement.
|
Bumpppp..
Dose any 1 no what is a safe psi to use from the turbo intake point & What points I need to block off ( v5 ) with catch can Pleeeeaaseees :notworthy |
I've watched the test done on YouTube two Aussie blokes did it . Much easier than reading it hope it helps
|
|
Originally Posted by r33gts2009
(Post 10875637)
Thanks for that ... Was a good watch :) |
Still need to No what pipework to block off on my v5 to pressurise the system
Can any1 help ???? I have a aftermarket turbo intake with 1 take off that goes to boost solenoid and also have a catch tank fitted .... Helllpppp :notworthy |
All times are GMT +1. The time now is 12:05 AM. |
© 2024 MH Sub I, LLC dba Internet Brands