photos of lower bug black zunsport grill
 

Any pics of a black zunsport lower grill please.

not yet but emmaroids has ordered one and im fitting it sometime this week so ill get her to post one up when it arrives.

Go to Zunsports web page and look at blobeye full grille pic, its my STI,they look good.

http://i28.photobucket.com/albums/c2...pbash20011.jpg

http://i28.photobucket.com/albums/c2...o/IMG_1121.jpg

:)

can the Zunsports badge be removed?

its welded on but im sure you could get it off if you got the right tools ;)

its welded on at 2 parts. only small though

yes i removed the first one i had mate, check my project thread

Nice one guys, thats one sexy car Steve!

http://i28.photobucket.com/albums/c2...o/IMG_1121.jpg

Looks nice :thumb:

Cheers fellas :)

That pics a couple of years old but its not changed much other than different fog covers now (and lamps removed). Actually got to take the lower zunsport grill off and get it blown over in black again - picked up a lot of silver chips in Germany (autobahns i guess). Thats the only problem with them (and the fact that you can't easily wash the bit behind them lol)

Here's mine that TT fitted today

http://i883.photobucket.com/albums/a...929_164159.jpg

looks wonky to me:lol:

thats because you're a spacker :lol1:

Looks good,I do prefer the bottom grills rather than the top ones.

http://i37.photobucket.com/albums/e6...a/IMG_6097.jpg

http://i37.photobucket.com/albums/e6...a/IMG_6100.jpg

genuine prodrive grill or added the badge?

if so, where did you source the badge? quite like that :)

The guy I bought it from did it, think you take off the self adhesive fixed ZunSport.. and stick the Prodrive one on... you can get the badge off ebay :)

thats what i did:thumb:

http://i890.photobucket.com/albums/a...422_113241.jpg

is that a stone in the mesh?

Its a screw holding the grill on :lol1:

The newage ones have 4 screws to hold them in place along the top (the centre two get hidden behind number plate). Can't see any screws on the hatch one, has it got some brackets to hold it in place?

hatch grille has three pegs at the top that go into small holes that are already in the under part of the front bumper, then it has long clips that hook over the rear part of the bumper.

you need a long thin screw driver to push the clip in position and it hold its tight :)

Better than the newage ones then, you have to screw it straight into the black plastic bit!

Mines held in by about 6 metal clips that hook around the bumper

http://i9.photobucket.com/albums/a75...s/IMG_1656.jpg