Can a v3 sti be mapped
 

As above

If not can you get a daughter board or is it a new ecu.
What are my opitons
Thanks kev

Yes you can get an ESL daughterboard for it fitted and mapped, PM for prices.

Hope this helps,

Graham

Pm for prices no re ply mate

Any one else

Hi. Fitted and mapped lots of these version 3 ESL boards now. Some cracking results and a great value option for you. Work out at £575 all in if that is of interest :thumb:

Where are you based ?

Hi mate im in grimsby

Often up that way chap or can meet you at a local dyno and do it there :thumb:

How far you deciding to go mate?

With an ESL ECU he can go as far as he wants.

Sorry fella, incredibly busy at the moment. Give me a call on 07773806255 if you want to have a chat about options and prices and we can go from there. I have a dyno to configure the mapping on and use the road to finish off, so we have the best of both worlds.

Graham

Nice one guys. What im thinking then is for abit more money i should get a simtec or something like that whats your thoughts

Not a lot of difference in running and driving cars with either ESL or Alcatek (old simtek) to be honest. There is slightly finer control on the alcatek (and more maps with the ugrade on the alcatek) but balance that against full OE engine management codes on the ESL and other factory features and I would bet money that you wouldnt be able to tell the difference on a day to day driving basis between the two.