help with putting engine back in
 

when i removed my engine there where to the studs at the bottom that when through the bell housing and done up with two 14mm nuts, question is, do you guys leave them in the block when re installing the engine or remove them and screw them in through the bell house into the block once engine is in place. cheers. martin.

i would leave them in as it will guide the engine into place

leave them in as its really hard too get at them after engine has been put back in
steering shaft get in way on O/S side and space is very tight on the N/S side

it can be done but its alot easy to leave them in

ok guys cheers :)