(possum) Link Ecu.. questions.
 

I have just recently purchased a 'possum' link for my scoob which is apparently a plug and play. I have some experience with link ecu, having installed one on my mx5 years ago and self tuned.

Are these really plug and play or does anyone know if I have to change any sensors, I remeber before I needed to install a map sensor previously.

Just seems a little odd to plug it in and get tuning..

Also anyone know if there are any link experts in the Kent area..

Meant to say it's for a 1996 Wrx

Thanks

Jim

Its a MAFless system so it may be a little more than plug and play. Bob Rawle maps them iirc. :)

As above, the man who knows these is Bob rawle.

My 98 classic still runs one and is a dream to drive at around 400/400, 2.5 forged engine.

I had one all done by Bob in a 99my It was ok but to be honest it was quite crude. You lost a number of features such as check engine and you may find you need to replace the original ECU board at MOT time for the emissions! Are they better now?

JohnD

Crude they are, but they produce the goods. Bob and Harvey were both impressed with mine.

Ok I am slowly finding out info, I need to beg,borrow, steal and or buy a link tuning module. Does anyone know of anywhere.. anyone in kent area have one I can borrow.. happy to leave deposit errr anyone have one in the back of the shed they wanna sell... ?

p.s. alcazar - that sounds like a nice car, would like to end up with a similar setup.

Cheers

Jim