Gasket Advice
 

Hi All,

I had my decat fitted by James at Greenwood Racing and then car mapped by Simon at JGM on Thursday.

Everything went very well except due to a little bit of crossed wires we were minus a 3" gasket to fit between my Milltek down pipe and the centre section of my Milltek exhaust.

James did a top job of getting it to fit with a little help from some exhaust paste to get me through my remap but now I need to get it sorted. My only issue is I do not know which gasket to buy, I have heard so much about cheap gaskets that fail and now I am pickled as to which one to buy.

Any ideas which one to use/buy?

Last question, what do you think of poly bushes for the exhaust?

My last scooby had them fitted when I had my Milltek fitted but I did not get them this time around and now there seems to be a little knock at low speeds or if I rock it.

I recorded by remap and stuffed it on Youtube should anyone wanna see.

http://www.youtube.com/watch?v=GeSsO...1&feature=plcp

Many thanks

Chris

Hi mate a friend of mine had a stainless steel gasket fabricated for his downpipe and only cost him around 15 quid, So that might be an option for yourself if you could find some one to make one for you :)

I think this is what your looking for :

http://www.ebay.co.uk/itm/3-De-cat-g...item3ca7ea8336

I bought a uppipe gasket off them last week,decent quality and quick delivery. :thumb: