need some advice .
 

hi rob bro here,

got my engine out and striped down and replacing all gasket and sorting out few oil leaks as someone has bodged my scoob so when i got the car i needed to sort out all these faults.

took my cylinder heads to my work and cleaned them in the part washer tank to get them all cleaned ready to go back on.
the following day i went to work and was planing to take my heads home and some ******* had nicked my cam position sensor and the brace which holds the camshaft down which also holds the cam position sensor:mad: .

Now i guess the next action is to replace the head as the cam brace brackets are a machined part and cant not just be replaced with another cam brace of another car right ????? is there any other way i can get around this ? cheers mark. :thumb:

Anyone.?