ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   ID of Fuel hose V5/6 STi (https://www.scoobynet.com/general-technical-10/922966-id-of-fuel-hose-v5-6-sti.html)

The Trooper 1815 29 January 2012 05:38 PM

ID of Fuel hose V5/6 STi
 
Anyone know the correct ID of the hose lines from the front bulkhead to the filter and then beyond to the fuel rails?

Thanks in advance :thumb:

The Trooper 1815 29 January 2012 07:27 PM

BTTT

ianbott 29 January 2012 07:35 PM

8mm :-)

The Trooper 1815 29 January 2012 09:11 PM


Originally Posted by ianbott (Post 10459189)
8mm :-)

Been told 6mm as well.

ianbott 29 January 2012 10:08 PM

I saw that on anothe thread but my fuel filter/fuel rail lines are standard and are 8mm. Maybe worth checking for sure.

The Trooper 1815 30 January 2012 07:21 PM


Originally Posted by ianbott (Post 10459585)
I saw that on anothe thread but my fuel filter/fuel rail lines are standard and are 8mm. Maybe worth checking for sure.

It's the inside diameter (ID(bore)) I am after to prevent confusion.

prodriverules 30 January 2012 07:25 PM

6mm Ian:thumb:

The Trooper 1815 30 January 2012 10:27 PM


Originally Posted by prodriverules (Post 10460973)
6mm Ian:thumb:

:thumb:.

I'll call tomorrow.

ianbott 30 January 2012 10:37 PM

I chcked mine today and it's deffo 8mm ID that's from the fuel pump to the feul filter and from the filter to the fuel rail. Same size on both my inlet manifolds, 1 being a 98 uk turbo and 1 being a 2004 uk sti. So might be worth getting a tape measure out :)

prodriverules 30 January 2012 11:46 PM


Originally Posted by ianbott (Post 10461515)
I chcked mine today and it's deffo 8mm ID that's from the fuel pump to the feul filter and from the filter to the fuel rail. Same size on both my inlet manifolds, 1 being a 98 uk turbo and 1 being a 2004 uk sti. So might be worth getting a tape measure out :)

Is that by pulling the pipe off mate as the end where it go's onto the hard pipe can swell from being pushed over the hard line making it seem larger?

ianbott 31 January 2012 07:50 AM


Originally Posted by prodriverules (Post 10461629)
Is that by pulling the pipe off mate as the end where it go's onto the hard pipe can swell from being pushed over the hard line making it seem larger?

No I actually have some left over pipe from when I replaced all my lines, and I also measured the steel hard lines that the rubber hoses push onto. I'm confused now lol.


All times are GMT +1. The time now is 07:23 PM.


© 2024 MH Sub I, LLC dba Internet Brands