|
Replacing a 2 port boost solenoid with a 3 port boost solenoid
Hi all first post here and first Subaru,
I have a Subaru Forester 2.0XT and I had it mapped. It would only boost up to 0.8bar so I have bought a 3 port boost solenoid of a classic. My question is can I just fit this then get it remapped or does it need to be done at the same time as the mapping? What size vacuum tubing do I need? Thanks for your help Dave |
Originally Posted by forester54
(Post 10450518)
Hi all first post here and first Subaru,
I have a Subaru Forester 2.0XT and I had it mapped. It would only boost up to 0.8bar so I have bought a 3 port boost solenoid of a classic. My question is can I just fit this then get it remapped or does it need to be done at the same time as the mapping? What size vacuum tubing do I need? Thanks for your help Dave Hi Dave I would suggest you get your mapper to do it at the time of re map as it will mess about with the map you have already, 4mm silicone pipe is needed fella. Hope this helps Rich |
Rich,
Cheers for the quick response I suspected that was the case Dave |
Welcome Dave,
You can also visit the Europe forum over on Subaruforester.org Lots of UK owners (and ex owners ;)) on there......... http://www.subaruforester.org/vbulletin/f75/ |
Thanks Don, will do
|
Originally Posted by Don Clark
(Post 10450604)
Welcome Dave,
You can also visit the Europe forum over on Subaruforester.org Lots of UK owners (and ex owners ;)) on there......... http://www.subaruforester.org/vbulletin/f75/ |
| All times are GMT +1. The time now is 04:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands