Boost controller help!!!
 

Hi all im fitting a hks electronic boost controller in my impreza and have a few questions. I think it is a hks III controller?

1. In the picture you can see the boost solinoide (thingy), do the three pipes go in place of where the 3 off the original solinoide go?

2. Do i have to disconnect the plug off the original boost solinoide? (So it as no use at all?)

3. Can i remove the whole original boost solinoide? (Or does it connect with the hks one?)

Hope you understand this as ive had a tiring day lol :sleep:

http://i1093.photobucket.com/albums/...a/SAM_0110.jpg

Come on some one must know or fitted one on there car?

1. Have you or are you going to be getting a remap for fitting this?

Small pipe on the right will go into a port on the inlet manifold

The other two pipes will go to turbo outlet nipple and the actuator

Not straight away but in the next few months yes.

Cheers for that.

Do you know if i have to remove and disconnect the old boost solinoid? And will this one fully replace that?
As this hks one is not connected to the ecu in anyway which i though it should be?

Im just confused with it.

You just remove the pipes that are connected to the standard boost controller, but you cannot remove it else it will put a CEL on.

Arrrr i get you now! So the new one wont need to connect to the ecu in anyway?

No but you'll NEED a remap unless your going to be running the EXACT same boost as the standard controller (no point in fitting a new one unless your going to get it remapped)

Cheers dude your a star. :thumb:

The ****ty thing confused me lol

The remap is the next thing. Cheers dude