Tuffnol spacers just under red manifold?
 

Hi all,

I've been looking at Tuffnol spacers for a while, can they only be fitted between the block and inlet? I wonder if you can just take the red inlet manifold off and not the section which holds the injectors and fit in between there?

http://www.carldavey.co.uk/product.php?id=5

the injectors are attached to the IM so have to come off too :)

Hmm, sounds a big job. I thought I could just take the red inlet off without the parts below (which I thought the injectors were fitted against).

all attached I'm afraid...have a look in my project thread and you 'll see some pics of the IM and the fuel rails; speaks a thousand words :)

Is that the words longest project thread? :norty: Which page(s) is it on?


What do you think of 3 mm or 8mm tuffnol? What difference in heat?

:lol: try page20\21 I think, can;t see photbucket at w**k :mad: :thumb:

Nope, guess again, checked upto 24/25...

And don't forget you need 2 sets of manifold gaskets aswell.

all I can say is you are heading in the right direction :p

;) Check