|
Engine management light on WRX
Hi guys and girls ;0). I have have a Subaru WRX 2002 brought secord hand direct from subaru and I keep getting the engine magagement light on when every I drive over 80 mph. I kept taking it back and they kept resetting engine magaement and saying bring it back when It comes back on which I did and I kept keeping the same answer bring it back again. I finally got them to replace the engine coils but again Getting the magagement light on so I took it to another garage they did me a engine magagement print out and I'm getting a misfire on cylinders 1 2 3 4 so they have recommended I replace all 4 coils again. But after speaking to a friend they have advised me to replace the spark plugs and leads.
SO THE QUESTION IS. Whats the spark plugs and leads I can buy for my year at a reasonable price and has any 1 else had this problem and if so how did they solve it. (my car is always mantained and not just raced about with no maintance) Many thanks. (and PLEASE HELP) |
i'm hoping someone technical may help you - I have a simialr problem.
My engine management light comes on during hard pulling in 3rd or 4th gear, it flashes and then stays on. It stays on for about 2.5 days and turns off again. I wait another week and it comes on again. The dealer I brought it from said the car showed it was lead 1. |
Originally Posted by Martin.dean1981
(Post 9657170)
Hi guys and girls ;0). I have have a Subaru WRX 2002 brought secord hand direct from subaru and I keep getting the engine magagement light on when every I drive over 80 mph. I kept taking it back and they kept resetting engine magaement and saying bring it back when It comes back on which I did and I kept keeping the same answer bring it back again. I finally got them to replace the engine coils but again Getting the magagement light on so I took it to another garage they did me a engine magagement print out and I'm getting a misfire on cylinders 1 2 3 4 so they have recommended I replace all 4 coils again. But after speaking to a friend they have advised me to replace the spark plugs and leads.
SO THE QUESTION IS. Whats the spark plugs and leads I can buy for my year at a reasonable price and has any 1 else had this problem and if so how did they solve it. (my car is always mantained and not just raced about with no maintance) Many thanks. (and PLEASE HELP) Sorry to hear your ownership isn't going so smooth. If you purchased the car from a approved Subaru dealer you would have had the warranty (12 months) . If it is within this time take it back or take it to another one matey. Where abouts is your location. Steve |
Hi thanks for the reply. I had the same Prob with it only flashing then saying on for a few days then going off but now it just stays on. I've spoke to a few ppl and they say the same thing change the plugs and leads because I only had the coils changed 5000 miles ago.
I live in Romford, Essex, UK. So if any 1 knows of a good garage around my area then please let me know. Mant thanks. |
Originally Posted by Martin.dean1981
(Post 9667511)
I've spoke to a few ppl and they say the same thing change the plugs and leads .
Sounds as if changing the plugs may be a good idea though. http://opposedforces.com/parts/impre...llustration_1/ |
Are the cars completely standard. Any exhaust modifications?
|
Mines completely standard - although if I change the exhaust with it cause the light to have a minor tamtrum? Anyone got any good suggestions to the best plugs to use - is it worth changing the coil packs too - i used to have a megane that threw out a coil every couple of months - drove me mad!
|
Nothing wrong with the coils or plugs IMO.
This code tends to be a bad earth from the engine when revved highly and is often accompanied with the cam timing error fault too. |
Bugeye ECU random CEL Generator LOL. Camshaft position sensor error common at high revs, sometimes goes after a clean of the sensor. You should have the historic code stored on the ECU even if the CEL light goes out.
The other one is a faulty neutral position switch throwing spurious misfire CELS. The joys of owning a bugeye :) Shaun |
I'm going to buy 4 NKG or Nology spark plugs today. Get them fitted and the engine light reset if I still get same problem then change the coils and hope for the best.
|
Best of luck mate. Hope it works ok for you.
Steve |
Originally Posted by Martin.dean1981
(Post 9671219)
I'm going to buy 4 NKG or Nology spark plugs today. Get them fitted and the engine light reset if I still get same problem then change the coils and hope for the best.
|
Originally Posted by dynamix
(Post 9667767)
Nothing wrong with the coils or plugs IMO.
This code tends to be a bad earth from the engine when revved highly and is often accompanied with the cam timing error fault too. Ok. But what can I do to put this fault right? Can you please advise me. I notice u deal with imprezas what is your location. If you are to far away from Essex. What can I advise my local garage to do? |
See my post number 9....... do a search on here for faulty NPS problems giving multiple misfire CELS on the bugeye..... for example.
https://www.scoobynet.com/general-te...ire-codes.html. Shaun |
I got a similar fault, if i do a constant speed say 70+10 my cel comes on and with the code reader i got it tell me its the sensor on the up pipe. this has only started since i put a strait thou 3" exhaust on it.
|
wrx,sti
What's the OBD code........ P0420? Shaun |
Originally Posted by wrx,sti
(Post 9671577)
I got a similar fault, if i do a constant speed say 70+10 my cel comes on and with the code reader i got it tell me its the sensor on the up pipe. this has only started since i put a strait thou 3" exhaust on it.
Martin - I am in Essex on monday - could pop in and check for you. Pm me your address |
Originally Posted by Midlife......
(Post 9671585)
wrx,sti
What's the OBD code........ P0420? Shaun Got to be that code. :Suspiciou Steve |
I have just re-read the OP post and need to ask a question.
Martin.dean1981 , does the car feel any different once the the light come on? Any smells etc? I think its a 2001 WRX thing. I remember my old WRX throwing up a code in the same place of the M25 if I was between the speeds of 70-80 mph. Any modifications to the car at all? Do you have a DV? Steve |
There r no mods to the car the codes are P0304 P0303 P0302 P0301 20B1 20B0. I work mon - fri and would b home for about 5pm. What time would u b planning on coming over at.
|
It would have been early afternoon.
Try the nuetral position switch and check the earths - reckon that will solve it rather than replacing all the coils/plugs .. |
Not to mention the cost of the new age coils :eek:
Very unlikely to be them in my opinion. Looks like you are in good hands with Dynamix on the case :thumb: |
Dynamix I just tried ringing yr number but no answer just answer machine is that yr number 07540 185754.
|
Originally Posted by Martin.dean1981
(Post 9672171)
Dynamix I just tried ringing yr number but no answer just answer machine is that yr number 07540 185754.
Will be around today though :thumb: |
Originally Posted by Midlife......
(Post 9671585)
wrx,sti
What's the OBD code........ P0420? Shaun |
EGT sensor too high.
|
Originally Posted by wrx,sti
(Post 9673031)
Its code P0546
|
More than likely the WRX pre-cat has been replaced..........and the new up-pipe either has no EGT sensor hole or it's been blanked off. I bet there is a spare connector by the offside suspension turret (where the EGT lead should be). LOL
Shaun |
yeah full decat and the EGT sensor is in the decat up pipe and still wired up, like i said it only started to happen when i went 3" all the way
|
wrx, sti
What turbo are you running in your WRX? Shaun |
| All times are GMT +1. The time now is 11:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands